RHINO ROBOTICS LTD.


PROPER MOTOR CABLE ALIGNMENT


If the Motors on your Rhino equipment have the round Optics, the ten pin flat Cable must be plugged into the motor as shown in the photograph below. The Cable is plugged in so that the Cable flows down the body of the Motor, from the Optics end to the Shaft end.

The red line or strip on the Cable (indicating pin 1) should be aligned as shown in the following picture.

NOTE: Damage to the unit (Motor or Controller) can occur if the Cable is plugged in the wrong way.


Return to FAQ page.


RHINO ROBOTICS LTD.

5928 State Route 128
Miamitown, OH 45041-0230
Telephone: 513-353-9772
Fax: 513-353-4040